At any point, running the program with the dongle installed resulted in the H0033 error. Two of the updates seemed to end with an error, perhaps because I did not reboot the PC after each (it was not clear whether or not to do this). Installation went through normal software install and then it also had 3 updates to install. The software is protected by requiring the user to have a USB dongle plugged in when running the program. My wife asked me to install her Viking embroidery “5D” software on her Surface Pro PC so she could use the touch tablet and pen to do graphics drawing and editing in the Design Creator. How I solved "Unable to access HASP SRM Run-time Environment? (H0033)"įirst of all, don’t stress! These instructions will most likely get you up and running with your 4D, 5D, 6D or other dongle-controlled program in short order.
0 Comments
Leave a Reply. |